2. How to use the stilts Powerstrider
a. Where to play with stilts
i. Make sure you use the Powerstrider on a level hard surface.
ii. Use it on a large and safe area to avoid hitting obstacles.
iii. Places to avoid the Powerstrider:
1. Parking and street: It is not recommended to play with the Powerstrider near streets or driveways to park. Avoid places with lots of traffic
2. Soft surfaces such as grass or carpet surfaces: A faulty spring on a soft surface can cause a fall in case of loss of balance.
3. Slopes, narrow streets, staircases: Sauter is not recommended in these places close and tilted. You may fall or hurt other people.
b. Preparation
i. Wear appropriate clothing and comfortable shoes;
ii. Find support raised so you can more easily lift you when you have the chaussé stilts.
iii. Place stilts on both sides of your legs;
v. Installation
1. Donning stilts one after another by following the instructions following:
2. Adjustments to roll bandages and keeping the knee.
3. Hold the knee with protective foam should touch the base of the kneecaps.
4. To adjust the poles to maintain the knee, slightly loosen the Allen screw in the collar when the plastic foam to protect the calf is tied.
5. The collar will slide up or down into the collar. It is not necessary to move the collar. If the collar has been moved, make sure it is straight when you tighten the screws. Tighten the screws firmly but not too much.
6. It is not necessary that the band behind the knee is very tight. This adjustment will enable the best possible stability and ease of use.
7. After adjusting the bandage and the arch of the knee and maintenance, prior to use, you must check the following:
i. The bolts are tight.
ii. The plastic collar to fix the pole to maintain the knee.
iii. General Instructions
iv. All pins (except the bolts on the plastic collar) are set by a special liquid to avoid stand out. If the special liquid is not applied correctly, please contact our customer service.
d. Protection
Place all accessories protections suggested by the seller (helmet, wrist guards, elbow pads and protective sheath of the knee (under the stilt)). The user who takes the initiative to fail to use one or all of the equipment named above, face a much higher risk of injury from falling or loss of balance.
3. Tips and tricks
a. The user must sit on a seat as high as possible and focus.
b. The straps attach to your feet should be tight. The two loops must be attached to the outside.
v. By adjusting the fastening system on the feet, one can obtain the desired position. The position of the ankle should be fixed.
d. Attach the strap from the pole to maintain the knee. Do not over tighten.
e. Put the second Powerstrider the same way.
f. Use a chair-type bar stool to help you get up easily. You can also remove yourself pressing against the wall or with the help of a friend.
g. Beginners should not jump or stand on one leg.
h. Skip to start slowly after you have practiced enough.
i. Walk cautiously stepping stretching of the legs so that they do not collide. Do not jump! Do that practice slowly and carefully.
* Special Notice to children *
(1) First steps: Installing a Powerstrider on a seat back with the help of an adult. The latter should settle in front of the child.
(2) An adult should help the child not to walk by holding hands. The child must walk slowly stretching his legs.
(3) It is impossible to stand without walking. The child should move or walk continuously to keep its balance.
(4) It can be dangerous for a child to be alone.
* Getting up after a fall *
Generally, a beginner can not get up unaided after a fall. For this reason you should not make your first steps without a friend. Once you are more confident in relation to the equipment, you can get up without help by kneeling on one leg and you get up by putting your weight on one leg.
4. Remove the equipment.
Use a raised support for removing the stilts.
Remove the powerstrider by pushing with your thumbs to the palms on the loops fixation.
5. Maintenance and cleaning.
• Remove dirt or dust after use. Clean the parts wet with a dry cloth to prevent rust.
• Any breach Powerstrider to be repaired before using it again after a thorough safety instructions.
• Repairs should be made only by an authorized representative or by a specialist that we have designated.
• Use only a dry cloth to clean the Powerstrider.
• It is important to ensure that no edge breaks the surface of the spring. Do not remove the dirt by scraping.
6. Product Warranty
This product, with the exception of spring, comes with a warranty of 3 months free entering into force on the date of purchase.
Breakage caused by normal wear, as well as those caused by improper use are not covered by warranty.
7. Specifications
Product: Powerstrider
Model: F501
Dimension 630 (Length) * 280 (width) * 320 (Height)
Weight: 6.3 kg / pair
Model: M511
Dimension 890 (Length) * 285 (width) * 395 (Height)
Weight: 9.6 kg / pair
 | 
